Industrial Rubber hose

Industrial rubber hose

Industrial rubber hose include of oil rubber hose, air rubber hose,water rubber hose, oxygen hose, acetylene hose, LPG hose, and twin welding hose. The characteristics of the rubber hoses are physiologically inert, UV resistant, ozone resistant, and high and low temperature resistant (-30 ℃ to 90 ℃). Strong resilience, resistance to compression without permanent deformation, oil resistance, stamping resistance, acid and alkali resistance, wear resistance, flame retardant and other properties.

The air rubber hose is suitable for various air compressors and pneumatic tools, conveying compressed air and other inert gases. Oxygen acetylene hoses are commonly used for gas welding, gas cutting, various gas shielded welding, plasma arc welding and cutting. There are two kinds of welding rubber tubes, one is an oxygen tube, the maximum pressure is 1.5MPa; one is acetylene tube, allowing the use of pressure of 0.5 ~ I.0 MPa. welding red and blue hoses  are suitable for conveying welding oxygen and acetylene gas, specifications is 5mm, 6mm, 8mm, 10mm, 13mm. Temperature range -35 ℃ to 90 ℃. LPG hose covered orange synthetic rubber, wear resistant, used in the transmission of liquefied gas, household gas and other gases, specifications as welding hose, stable range of -40 ℃ to 90 ℃.

The correct use of industrial rubber hose it's very important to determine the length of industrial rubber hose and you should also check if the conditions of use of the industrial rubber hose meet the requirements of the selected hose. It should be ensured that the industrial rubber hose you will use is the most suitable.In particular, it should be noted that sudden changes in pressure or pressure peaks exceeding the maximum allowable will greatly reduce the life of the industrial rubber hose. If you install the rubber hose so that it's bending radius is less than the specified minimum value, the life of the rubber hose will be greatly reduced. Therefore, before installation, it is recommended that you consult with the use information, especially the bending radius of the rubber hose. After use, it is recommended that you empty the hose. If necessary, it should be cleaned. Inspection: The rubber hose must be inspected after each use to ensure that no structural damage has occurred. Due to the natural nature of rubber, the physical properties and performance levels of all rubber products will change.  However, it may also be accelerated due to several factors or a combination of several factors. Other materials used to reinforce rubber hose may also be negatively affected by improper storage conditions. A rotation planning system should be adopted to shorten the storage time of industrial rubber hose as much as possible. If long-term storage cannot be avoided, industrial rubber hose should be thoroughly inspected before use.